gooffront

Big oops!!! Bulkhead C is a bit floppy. I made a backup brace for the top part, but didn't make one for the bottom. Big mistake!!! Look at the picture and you will see where Bulkhead C bent in the lower portion. Do to my interest in getting it drilled and cleco'd, I didn't notice it until I was about 3/4 of the way done <sigh>. The end result is a ruined skin.

Disclaimer! Material and comments on this site is INFORMATIONAL only. What worked for us, does not necessarily mean it will work for you. Anything that you attempt from this site, you do so at your own risk.

Disclaimer! Material and comments on this site is INFORMATIONAL only. What worked for us, does not necessarily mean it will work for you. Anything that you attempt from this site, you do so at your own risk.

Established September 2001 © Moon's Designs 2001-2002 "All Rights Reserved" No portion of this site may be duplicated or redistributed without expressed written permission

Established September 2001
© Moon's Designs 2001-2002 "All Rights Reserved"
No portion of this site may be duplicated or redistributed without expressed written permission